I have a mid 90s Stallard micro ready to go just rebuilt car from bare frame up and just put over $500.00 into the motor to get it running. Has a 91 honda cr motor just rebuilt never raced only started and ran once sence was rebuilt. Cylinder was all remachined and nickasealed brand new piston, rings, push rod, and wrist pin. I had the car stripped down to bare frame and painted frame as can see in pics and put car all back together this thing is ready to be raced. $1,200.00 obo Can call my cell Jerime at 717 513 0101 car is located in Burnham PA. I have a lot of time and money into this car but not time to race it now that i went back to work. Has to go someone make me a offer.

Is this car still available... Can you let me know if your car fits the description of what the rules state?? Thank you.

1. Car must use a used Micro Frame chassis and cage.
2. Wing not mandatory, but recommended.
3. A gear ratio of 5.74 to 1 or higher is legal.
4. Minimum drive ratio is 5.73 to 1.
5. Hoosier tires only.
6. Max tire circumference 65".
7. 550 lb. Minimum weight after feature.
8. Driver and arm restraints are mandatory.
9. Starter switch must be in reach of driver.
10. Chain guard must be constructed to prevent chain from
hitting the driver in case of chain failure.
11. Front and rear bumper to be 4" to 6" narrower than the over
all width of the front and rear tires. Front bumper to be a
loop style bumper.

Engine will be 9 H.P. Honda GX 270 Industrial - Model QAEZ, Honda part #558400 with electric starter that is functional.
1. Governor is not mandatory.
2. Counter balance shaft is mandatory.
3. Air cleaner must be stock as per O.E.M.
4. Must run stock 9 HP Cam; lift and profile subject to degree
wheel and dial indicator tech. No aftermarket reground cams
permitted. Compression release must be functional.
5. All valve train components must remain stock. No tech
on valve lash adjustments.

6. Stock 9 HP carburetor only; bores, venture, jet, orifices,
emulsion tube and other internal part diameters are subject to
tech against a known stock 9 HP carburetor.

7. No lightening of flywheel; must contain all internal magnets
and the generating coil intact and functional as per O.E.M.
8. Combustion chamber subject to minimum volume cc tech.
Multiple head gaskets may be used to meet min. volume tech.
9. Ignition timing must remain in stock location. Subject to
degree wheel BTC tech.
10. No porting, polishing, beveling or adding epoxy. Removal
or additional of material in port areas is not permitted!
11. Stock bore and stroke only.
12. Any component not mentioned is to remain as per O.E.M.
13. Do not read anything into the engine rules what is not there!

Clutch is to be shoe style only. No plated type disc clutches.


Fuel/Exhaust System
1. Pump gas only. No hot fuel or racing gas.
2. Fuel subject to tech by electronic meter, water test or
gas calibrated hydrometer.
3. Gravity fed fuel system only.
4. Muffler must be factory only. Exterior and outlet hole must
must remain stock appearing. Exit hole length and maximum
inside diameter subject to tech.
5. No flammable oil additives. Oil subject to flame test after
feature event.

is it still for sale? is there any possible way to ship it?