please post any questions or ideas so they can be clarified and included in this rule change proposal......I want everyone to be well informed and educated with no gray areas or anything left out so we can have an alternative induction system option next year

feel free to pm if you do not want to post on this thread...your support is greatly appreciated


thanks

Mike PJ

please post any questions or ideas so they can be clarified and included in this rule change proposal......I want everyone to be well informed and educated with no gray areas or anything left out so we can have an alternative induction system option next year

feel free to pm if you do not want to post on this thread...your support is greatly appreciated


thanks

Mike PJ Sure hope it goes this time PJ. :cool:

One thing we need to decide is if we are going to allow all throttle bodies to be open (run anything you want) or only allow the MFI to run non stock throttle bodies. One idea is to only allow current production model MFI throttle bodies only.

One thing we need to decide is if we are going to allow all throttle bodies to be open (run anything you want) or only allow the MFI to run non stock throttle bodies. One idea is to only allow current production model MFI throttle bodies only. JMO It should be with in a stock MM range & not allowed to get out of hand. No sence shooting it in the foot before it gets started. :eek:

One thing we need to decide is if we are going to allow all throttle bodies to be open (run anything you want) or only allow the MFI to run non stock throttle bodies. One idea is to only allow current production model MFI throttle bodies only.

I have no problem with that mike either way only because a 600 motor will only take soo much fuel and air but in the sport of keeping it cost effective i would agree to what is currently offered to the general public buy current mfg's not some custom cnc'd set from someones garage

JMO It should be with in a stock MM range & not allowed to get out of hand. No sence shooting it in the foot before it gets started. :eek:

i also agree with this and i can attest that my engler mfi was/is the same mm as the factory yamaha efi


all good points...