There is no content in this section
Makes sense. I will look into a stroker 66.4x76 setup for my backup engine. That should give me room in the future to go to a 68x74 if I score a cylinder
smahala Yesterday, 12:58 PMThe short version is, that a stroke increase offers the opportunity for increased port/time area values without increasing duration. When an engine is
Mrutherford Yesterday, 09:48 AMI have an all black 2 mil with Engler electronic fuel injection. Motor is fresh and the injection was just serviced by Engler.
7500 plus shipping.
Check out the track expansion and all the new renovations at LRSPEEDWAY.COM The tack is going from 1/8 mile to little bigger tan 1/5 mile in the race
MEYERSRVLIMEROCKSPEEDWAY 02-18-2019, 04:12 PM2011 PDX5 Roller - $10,000
1. 4-Bar torsion, Panhard Rear (Adjustable)
2. (2-3) 1 ? ? Rear Axle with extra spacers and spare bearings
I am rebuilding the engine that I acquired with my car. It is a 68.5mm bore with stock 72mm stroke. I'm rebuilding the bottom end due to a cracked case
smahala 02-18-2019, 01:42 PMThanks for the help guys. I printed off some setup info from Hyper and Foz
smahala 02-18-2019, 01:10 PM
have (2) 2005 yamaha r6s engines
still in bike
leemajors Yesterday, 08:33 PM900 ea
404-260-019nine text
770-767-061seven talk
thx
can provide pics